Building a Foldable 3D-Printed Long Range FPV Drone - Part 2

Подробнее о видео

The wait is over! You asked for the STLs, and here they are! 🚀
👉 Part 1:
🕹️ STL-Files:
In this video, I’ll walk you through all the improvements I made to the foldable 3D-printed FPV drone, how to assemble it, and where to find the STL files. If you’ve been following this project, now’s your chance to build your own!

🕹️ You can also fly this drone in LiftOff: Micro Drone—check it out here:

🛩️ More FPV Drone Builds:
⭐️ My 1st Year FPV:

📊 All my quads with build links, coupon codes & more can be found here:

Chapters:
00:00 - Intro
00:32 - What's New in This Version?
02:15 - Use these Print Settings
02:40 - Assembly Guide
04:55 - Important Step During Assembly
05:30 - Important Betaflight Settings
06:50 - Happy Flying!


Print Settings:
* Layer Height: 0.2
* Bottom Shells: 3
* Top Shells: 4
* Infill: 15%
* Speed: 120mm/s

*Disclaimer:*
Advertisement / Affiliate Links (Amazon, AliExpress, Banggood) – As an Amazon Associate and participant in other affiliate programs I earn from qualifying purchases.

Parts: 
* AIO FC: * 
* Battery: *  (Pick a good one!)
* 4x 3mm x 41mm Carbon rods:  * 
* Motors:   * 
* Cheaper Motors:  * 
* VTX:  * 
* Camera: *
* Props: *
* 6x M2 x 2.5mm x 3.2mm Threaded Inserts: *
* 1x 10mm x 3mm, 1x 6mm x 3mm neodymium magnet: * 
* Filament: *
* My 3D Printer: *
* 4x M2 x 6mm Screws
* 4x M2 x 16mm Screws

Are you looking for the STL-files? Watch the video :-)

Accessories:
* Remote Control: *
- Electric Screwdriver: () ()
- Best Beginner Soldering Iron:
* Analog Goggles: *
* Soldering Station: *

My Setup:
* Macbook: *
* Camera: *
* Monitor: *
* LEDs: *


Links marked with a * are affiliate links. If you make a purchase through these links, I earn a small commission at no extra cost to you.

Music from #Uppbeat (free for Creators!):

License code: UADXRSPG4QLZ0HHK

#3Dprinted #FPV #DroneBuild #DIYdrone #FPVlife #Betaflight #Quadcopter #DJI #LiftOffMicroDrone