Fusion 360 for Beginners - Model a Box & Lid with Screws - In-Context Design - Lesson 9

Подробнее о видео

In this tutorial, you will learn an absolute ton about sketches, extruding, in-context design, joints, fasteners, and so much more! Hope that you benefit from these videos. If you do, please like and subscribe. If there is something else that you’d like to learn or are finding difficult with Fusion 360, please drop a comment below. We will do our best to tackle that problem in the near future.

Support us on Patreon:

📚 Check out our Udemy course:

💰 Save $50 on a Fusion 360 subscription by using this referral code:


Here’s some of the gear I use and can recommend: (Please note these are amazon affiliate links and I may receive a small commission, which is not added to the cost of any item, when you purchase products through my links)
🐁 3D Connection SpaceMouse Pro:

00:00 - Intro
1:17 - Let's dig into it - What we'll learn
1:45 - Look at the drawings
3:01 - Create your components
3:35 - PLEASE TAKE NOTE - Component Activation
4:00 - Box drawing
4:55 - Model the box already!
7:08 - Offset sketch feature
10:16 - Create them tapped holes
15:06 - In-context design
19:55 - Project tapped holes to c-bore
22:55 - Joints
24:57 - Mate the lid to the box
26:52 - Insert them screws
27:47 - McMaster
29:44 - Capture position?
31:05 - Join the screw to the hole
32:23 - Review

#learnit #fusion360 #tutorial #drawings #manufacturing #beginners