Building a Foldable 3D-Printed FPV Drone - Part 1

Подробнее о видео

I wanted to build a 3D-printed, foldable drone with a long range, but nothing went as planned.
👉 Part 2:

⚡️My 1st Year FPV:
From endless troubleshooting to surprising test flights, this project took me on a wild ride! Stick around to see how I tackled every challenge and what this drone is truly capable of!

❌ My biggest Mistake:

🛩️ Start building your first 3.5-INCH drone:

📅From Week 1 to Week 52:
---------------
Parts:
- FC: *
- Battery: *
- Carbon rods: *
- Motors: *
- Cheaper Motors: *
- VTX: *
- Props:

Accessories:
- Remote Control: *
- Best DJI Goggles Face Mask: *
- Battery Charger: *
- Electric Screwdriver: *
- Soldering Station: *

My Setup:
- Macbook: *
- Camera: *
- Monitor: *
---------------
Links marked with a * are affiliate links. If you make a purchase through these links, I earn a small commission at no extra cost to you.

Music:
Music from #Uppbeat (free for Creators!):

License code: W17RPWEROGUZXCWG

Music from #Uppbeat (free for Creators!):

License code: DCHNA7LMN5WNX4SD

Song: Avi Snow, Sync - Alright [NCS Release]
Music provided by NoCopyrightSounds
Free Download/Stream:
Watch:

Big thanks to @DaveCFPV for his amazing NanoLongRange project—it was a huge inspiration for this build! 🙌
The #NanoLongRange Part II by Dave_C FPV:
#NanoLongRange by Dave_C FPV:

Which LAYER HEIGHT gives you the STRONGEST 3D prints? by CNCKitchen
Link to @CNCKitchen Blog:



#NanoLongRange #3dprinted #3dprinter #fpv #fpvbuild #AOS35 #diatone #emax #xing #betaflight #iflight #tatturline #fpvtutorial #fpvlife #drone #quadcopter #dji #caddx #djiintegra
#speedybee #iflight #geprc #mark5 #fpvfreestyle #xing #ovonics #cnhl