How to Install a Battery Kill Switch

Подробнее о видео

Learn how to install a battery cut-off switch that kills the engine and all electrical power to-and-from the battery. I also show you how to crimp battery cables using a hand crimper, hammer crimper, and hydraulic crimper, so you will learn each method and how to get perfect crimps.

Extendable Ratchet Set:
Jig Saw:
Drill:
Impact Wrench:
Angle Grinder:
Heat Gun:

Kill Switch:
Small Wire Crimper:
Hammer Crimper:
Hand Crimper (and cable cutter):
Hydraulic Crimper:
Terminal End Kit:
2 Gauge (7mm) Wire:
Hole Mount Zip Ties:
Zip Tie Mounts:

How to Install a Kill Switch:
Parasitic Draw Test:

0:00 Intro
1:32 Tools and Products
5:40 Wiring Diagram
6:19 How a Kill Switch Works
11:20 How to Crimp Battery Cables
19:50 Easy Way to Add Split Wire Loom Tubing
20:29 Installing the Battery Cables
24:10 Organizing the Wiring
26:12 ECU Cut Off Wiring
31:54 Kill Switch Panel Fabrication
37:47 Panel Installation
39:20 Testing the Kill Switch

→ As an Amazon Associate I earn from qualifying purchases.
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:

**If the video was helpful, remember to give it a "thumbs up" and consider subscribing.**

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.