
*Friends, today I am back with a new long video.And in this video, I made a small type of AC because it's summer now and it's very hot outside, so it's uncomfortable to stay at home.And to remove this discomfort, I have come up with this video on how to make an air conditioner.I used a Pelta model to make this air conditioner.I installed a water block on the hot side of the Pantier module to cool the hot site of the Beltier model.And I also used a water pump to move water through this blog.And I installed a heat sink on the side of the Peltier module that is cooled and installed two high-speed fans on both sides.As a result, cold air will pass through the heating element of the tee and exit to the outside.
How It Works:
I used a Peltier (TEC) module as the main cooling element. The Peltier module creates a temperature difference when powered: one side gets cold, and the other gets hot.
To cool the hot side efficiently, I installed a water block and used a water pump to circulate water, which helps carry away the heat much faster.
On the cold side, I attached a heat sink and mounted two high-speed fans—one on each side—to blow air across the cold surface. This setup pushes cool air out into the room, helping to lower the temperature.
Materials Used:
1.Peltier module (TEC 12706/12715 or similar)
2.Water block and water pump for hot side cooling
3.Heat sink for the cold side
3.Two high-speed fans
4. 12V 30Amp Battery
5. Water Pump
6.Swtich
Power supply (12V recommended)
Thermal paste or epoxy for better heat transfer
Why This Works:
The Peltier module uses electricity to move heat from one side to the other. With water cooling on the hot side and fans on the cold side, you can create a simple but effective homemade air conditioner.
If you find this project helpful, please like, share, and subscribe for more DIY solutions to beat the heat!
#DIY #trending #Cooler #rConditioner
@SamarExperiment @TechnicalIND @TechnicalSokil @MRINDIANHACKER @CrazyXYZ