My First FPV Build Was a Nightmare!

Подробнее о видео

Building your first FPV drone can be tough, and I definitely made some mistakes along the way.
👉Silent Build:
⭐️3D Printed Drone:

In this video, I take you through my first analog FPV build, showing you the process step by step and reviewing what I would do differently next time. If you're new to building an FPV drone, this video will help you avoid common mistakes and make your build process smoother.

*Disclaimer:*
Advertisement / Affiliate Links (Amazon, AliExpress, Banggood) – As an Amazon Associate and participant in other affiliate programs I earn from qualifying purchases.

📊 All my quads with build links, coupon codes & more can be found here:

Parts Used in This Build:
* Frame: AOS 3.5 EVO V1.2 ()
* Flight Controller & ESC: Mamba F740 AIO () ()
* Motors: 4x iFlight Xing 1504 3100KV Brushless Motors () ()
* Receiver: ExpressLRS (ELRS) Receiver ()
* VTX: SpeedyBee TX800 Analog VTX ()
* Camera Caddx Ant Nano: () ()
* Battery: Tattu R-Line 4S 850mAh () ()

🛩️ More FPV Drone Builds:
⭐️ My 1st Year FPV:

Accessories:
* Remote Control:
- Electric Screwdriver: () ()
- Best Beginner Soldering Iron:
* Analog Goggles:
* Soldering Station:
* Wire Stripper:
* Silicone mat: () ()
* Flux:

My Setup:
* Macbook:
* Camera:
* Monitor:
* LEDs:

The Links are affiliate links. If you make a purchase through these links, I earn a small commission at no extra cost to you.

Video Chapters:
0:00 Intro
0:12 Building the Frame – Mistakes to Avoid
1:57 Motor Installation
4:09 AIO Stack Setup
6:24 VTX Installation
8:14 Camera Installation
9:57 Soldering Motors
14:00 Soldering XT60
17:00 Soldering VTX
18:38 Soldering ELRS Receiver
19:12 XT60 Soldering – Did I Mess This Up?
20:14 Final Assembly
21:11 Smoke Test
22:34 Final Result
22:45 Flight Footage

Topics Covered in This Video:
✔️ How to build an FPV drone step by step
✔️ How to solder FPV motors correctly
✔️ Common mistakes when building an FPV drone
✔️ How to install an ExpressLRS receiver
✔️ How to connect an analog VTX
✔️ How to solder XT60 (wrong)
If you're looking for a beginner-friendly FPV drone build guide, this video will help you understand the basics and avoid some of the common errors I made.

#FPV #FPVDrone #DroneBuild #FPVBeginner #SolderingTips #AnalogFPV #ELRS #FPVFreestyle #DroneRacing #Quadcopter