
Tools:
Mini Pry Bars:
Nice Funnel:
Extendable Ratchet Set:
7mm Punch:
2lb Hammer:
Locking Needle Nose Pliers:
Click Torque Wrench:
Ramps I use:
Parts:
Honda Manual Transmission Fluid:
OEM Shifter Seal:
Short Throw Shifter:
Poly Bushings:
Shifter Ball Seat and Dust Boot:
303 Rubber Vinyl Protectant Spray:
Paint Supplies:
Rust Encapsulator Spray Paint:
Full Face Respirator:
P100 Filters:
Plastic Scrapers:
Acetone:
Wire Wheel for Grinder:
How to Install a Kill Switch:
How to Install a Short Throw Shifter:
How to Repair a Rust Hole:
0:00 Intro
1:50 What causes a loose shifter
2:46 Tools and products you need to rebuild stick shift
4:15 How to remove stock shifter
5:31 How to remove the shift linkage
8:37 How to replace a leaking transmission seal
13:24 How to remove and paint rust
17:00 How to rebuild a stick shift linkage
25:44 How to install rebuilt shifter linkage
28:45 How to replace a ripped shifter boot
→ As an Amazon Associate I earn from qualifying purchases.
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing.**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.