
Materials:
Headlight:
Plastic container lid, 2-inch PVC end cap, 2-inch clear plastic circle, aluminum foil (or use shiny origami paper), 2 hose clamps (or you can use zip ties), thick washer, flat washer and hex nut, tap-washer, bolt and nut, 30cm of copper wire (stripped wire), nine white 3.5V bright LEDs, 2 pieces of 10cm wire, 3.7V lipo battery with connector, small On/off switch.
Tail lights:
10x3cm laminated thin cardboard, 3 red LEDs, one 3v resistor, 3 white plastic bottle caps, 3 red reflective covers for tail lights (found in LED collar safety lights), copper wire, 3.7V lipo battery, On/off switch, 4 zip ties, two 10cm long wires.
Wheel lights:
Half inch PVC clear transparent hose (length depends on the perimeter of your bike's wheel), 22 LEDs per wheel (11 LEDs of one color and 11 of another color), 2 copper wires, 3V battery supply, On/off switch, masking tape, and a 3V resistor (only if you are using a battery higher than 3V).
Chassis lights: Half inch PVC clear transparent hose, 10 red LEDs, 3V battery supply, Switch, masking tape, copper wire, and 2 electrical wires.
Music credits:
Jim Yosef - Eclipse [NCS Release
Free Download / Stream:
Warriyo - Mortals (feat. Laura Brehm) [NCS Release]
Free Download / Stream:
#LEDbicycle #pimpmybike #DIY